Sta-Rite P43B0005A2-c Pentek Submersible Motor
PENTEK® XE Series submersible 4" high-thrust motors are built with the latest design, manufacturing and testing technology. They feature laser-welded 304L Stainless Steel construction, higher thrust capacities, and higher efficiencies. These motors incorporate "encapsulated, epoxy stator design," and professional grade Class F insulation provides longer life in harsh environments. Each motor is 100% factory pressure and run tested to support our quality standards.
Key Features:
- 1/2 Horsepower
- Volts/Hz/Ph - 230/60/1
- Shell - 304 Stainless Steel
Specifications:
NUMBER OF WIRES: 2 or 3 (plus ground) (Model Dependent)
HORSEPOWER: Available in 1/2, 3/4, 1, 1-1/2, 2, 3, 5, 7-1/2, and 10 HP
VOLTAGE: Single Phase: 115v or 230v AC / Three Phase: 200v, 230v, 460v, 575v
PHASE: 1- or 3-phase (model dependent)
FREQUENCY (Hz): 60
AMP DRAW and SERVICE FACTOR: (model dependent) See Spec Sheet in Resources for details
END BELL: 304 Stainless Steel
SHELL: 304 Stainless Steel
MOTOR SHAFT: 17-4 Precipitation Hardened Stainless Steel
INSULATION: Class E, 311 degrees F (155 degrees C)
MAX. WATER TEMP.: 86 degrees F (30 degrees C)
FASTENERS: 304 Stainless Steel
SAND BOOT: Nitrile
CABLE: 48", Field-Serviceable, Controlled Compression Design, UL and CSA Approved
DIAPHRAGM: EPDM
THRUST BEARINGS: Kingbury-type, Pivot Shoe, Carbon Graphite Mating Ring
THRUST LOAD CAPACITY: 700 lbs